LumiDesk Forum

Hello,

I have made a Que list for the Par cans ( 4 on the Dmx blok ), for the scans ( robo scans ) and seferel differnce effects.

When i play in LIVE mode it is no problem when i start with a ceu for my Par cans and later start A ceu for the Scans. ( the Par cans keep performing )

When i start with a ceu for the Scans its no problem, but when i wont to start than ia ceu for the Par cans, the Scans mirror move to particuler angle and stay there .( the keep on performing the rest of the program that is in that ceu for the scans . )
The Par cans keep performing.

What am i doing wrong ....

Greets MArk

Hello Mark, are you using the latest version ?
Check the DMX Out view to see if everything look as it should

Thanks

Hello,

Yes i am jusing the latest verion..
What do you mean with DMX Out view

Hello, you can get the view under the Tools tab -> DMX Level

Thanks

Ah , you main DMX levels, Yes i can see them. but to by onesly , do you want me to tell you what i see,, i tink its a litle bit to much and go to fast..

And i think it is not doing what i wont.. because , that was my problem ... in the first place.

Grtn Mark

In the maen time i made a complete new show. and i found out i have the same problem ...

If i mix other ceu list sequence there is no problem . only with the par cans qeu.