LumiDesk Forum

Hello ,

I have a problem white the 3D color weels and gobo wheel spimming .
My scans are re acting as the have to in real life as the are programd in the LUMIDESK programing, but i do not see the gobo´s spining in the 3D visueliser and also not the color wheel spinning .

GREETS MArk

P.S. i´m jusing self made SSl file for my scan , as the from Lumidesk not exist.

Hello Mark can you send me your SSL file please
Thanks

And ,

Is there any progres

Grtn Mark

Hello Mark can you send the SSL file please? I didn't receive it

Thanks

I did send it to [email protected].

Grtn Mark

I yust send it again 5 minutes ago.

Grtn MArk

Hello Mark how are you? can you send me an email please
Thanks

Wat is happening now ??

I do not understand enimore ?? i send an e-mail on the 8 december to info@lumidesk and nothing heppens anymore ??


Grtn MArk

Hello Mark, I see the problem on the SSL profile, you need to right click on the Clockwhise rotation and enter the correct DMX Min and DMX Max value that correspond to your gobo range, in your case 150 to 255
do you see what I mean ?

Thanks

Hello , finally,

Yes i am hapy it works, i did the same with the color because it was the same problem with the color . it both work now. all that i dont understand why . but i think thats because i am not into configure mode now for a fhew weeks anymore.

Thanks again and greets from holland...
Mark