LumiDesk Forum

Since the new upgrade I'm having a couple of problems.

1. after working on the desktop and switching back and forth from desktop to live, I find that sequences stop working and I have close the software and restart it. It happens several times during programming.

2. I'm also finding that the software is locking itself out and I get the not responding please close and it takes several tries to get the software to open.

Not sure if it didn't download correctly or what but its getting very tiresome to have these problems right now.

any thoughts?

Still having problems?

yes I am still having problems, it takes several tries to get Lumidesk to open

I found I had to restart Lumidesk a few times this past Saturday night when we were setting up. Julien! Where are you??

I have problems too.
Sometimes when I switch from live mode to desktop mode i cannot control some fixtures.
Then I have to restart lumidesk.

I got a reply from Julian. He is in Germany right now. He suggested to try the current beta version.

Hello, did you test the Beta version, that look like an hardware issue. Did you update the interface to the latest firmware ?

Thanks